Looking to resurface your fiberglass pool in Perth? You’ve come to the right place! In this guide, we will walk you through the process of fiberglass pool resurfacing, including what materials you will need and how much it will cost. We’ll also give you tips on preparing for the resurfacing process. So whether you’re a DIY enthusiast or you’re looking to hire a professional, this guide has everything you need to know about fiberglass pool resurfacing in Perth.
The first thing you need to do is gather the materials you will need for the resurfacing process. This includes fiberglass pool resurfacing Gelcoat, a resin-based primer, and non-woven polyester fabric. You will also need some basic tools, such as a putty knife, sandpaper, and measuring tape. The amount of gelcoat you will need will depend on the size of your pool. A good rule of thumb is to use one gallon (about four liters) of Gelcoat for every 100 square feet (nine square meters) of surface area.
Once you have all of your materials, it’s time to start prepping your pool for resurfacing. The first step is to clean the surface of your pool. This means using a power washer to remove any dirt, grime, or debris from the surface. You should also take this opportunity to inspect the surface of your pool for any cracks or damage. If you find any cracks, you will need to repair them before proceeding with the resurfacing process.
After cleaning and inspecting your pool, it’s time to apply the gelcoat. Begin by mixing the gelcoat according to the manufacturer’s instructions. Once it is mixed, you can start applying it to the surface of your pool with a paint roller. Work in small sections, and be sure to smooth out any bubbles as you go. Once you have finished applying the gelcoat, allow it to cure for 24 hours.
After the gelcoat has cured, you can begin applying the fibreglass matting. Start at one end of the pool and work your way around, overlapping each piece of matting by about six inches. Be sure to smooth out any wrinkles or bubbles as you go. Once you have finished applying the fibreglass matting, allow it to cure for 24 hours.
After the fiberglass matting has cured, you can apply the final layer of gel coat. Again, start at one end of the pool and work your way around, overlapping each piece by about six inches. Once you have finished applying the gelcoat, allow it to cure for 24 hours before using your pool again. Thanks for reading!
For more information on fibreglass pool resurfacing Perth, check online.